Restarting M2; Electronic Board Flash?
Posted: Sun Jun 10, 2018 10:14 pm
Hey All.
Purchased an Electronic Board from Amazon for my M2. Did so before a prolonged illness, so I don't recall the vendor. Hooked it up and saw no data on the screen and no movement on any axis when using Repetier's click to move extruder function. The M2 was working just fine with Repetier and the original board (ruined due to bad power plug connection mounting detaching).
Remember being told by Amazon seller that the E-board would need some "flash" to make it work. Looked up "flash M2 Electronic Board" on google and didn't hit anything helpful. Any suggestions?
I will probably just purchase another E-board directly from MG, but want to find out if the "new" board is salvagable.
Thanks.
Kevin
Purchased an Electronic Board from Amazon for my M2. Did so before a prolonged illness, so I don't recall the vendor. Hooked it up and saw no data on the screen and no movement on any axis when using Repetier's click to move extruder function. The M2 was working just fine with Repetier and the original board (ruined due to bad power plug connection mounting detaching).
Remember being told by Amazon seller that the E-board would need some "flash" to make it work. Looked up "flash M2 Electronic Board" on google and didn't hit anything helpful. Any suggestions?
I will probably just purchase another E-board directly from MG, but want to find out if the "new" board is salvagable.
Thanks.
Kevin