Page 1 of 1
Different looking v3b
Posted: Sun Nov 10, 2019 7:13 pm
by bill_i_am
Hi, I have a used M2 with no documentation. The v3b hot end it has (aside from being clogged) looks different than other v3b images I have found. Any ideas what the vintage is?
Three images
https://imgur.com/a/ucHvHQf
BTW, The nozzle says MG .50
Thanks
Re: Different looking v3b
Posted: Wed Nov 13, 2019 10:59 pm
by sthone
Looks like a V3B to me but there were two revisions apparently.
http://makergear.wikidot.com/m2-extruder
Re: Different looking v3b
Posted: Tue Jun 30, 2020 6:03 pm
by bill_i_am
Thanks for the reply! Back on the forum with another problem. I don't usually look at forum as I am such a noob that I don't feel I have much to contribute. I did end up putting on a V4b hotend along with a lot of other work. Someone had partially disassembled the M2!? Luckily Support was ultra supportive!