Octoprint version

Have questions or comments about Simplify3D, Slic3r, Cura, Reptier, etc? Or wondering about which CAD software to use...discuss it here...
Post Reply
Deduin42
Posts: 1
Joined: Wed Jan 09, 2019 2:07 am

Octoprint version

Post by Deduin42 » Thu Jun 27, 2019 1:28 pm

Is there any anticipated releases for newer versions of the Makergear fork of Octoprint? Current released version 1.3.6 was in March over a year ago, and the 1.3.10.1 pre-release test build hasn't been updated since December. The original Octoprint is at 1.3.11 and enables use of a lot of newer plugins things that we would find useful such as better timelapse, print time estimation, etc. that can't be loaded with this old of a revision.

If nothing is moving forward, can I create an installation using the official fork of Octoprint and get Makergear functionality with plugins for the Makergear setup, etc.?

Post Reply