Default M2 Settings

Have questions or comments about Simplify3D, Slic3r, Cura, Reptier, etc? Or wondering about which CAD software to use...discuss it here...
Post Reply
Posts: 76
Joined: Thu Apr 10, 2014 12:07 pm

Default M2 Settings

Post by KeithA » Fri Apr 11, 2014 3:03 am

I modified the default M2 profile in Simplify3d. Is there a way to reset the profile? I am sure reinstalling would work but was trying to determine if there is another way to get it back.


User avatar
Posts: 2888
Joined: Wed Apr 09, 2014 11:30 pm
Location: mullica, nj

Re: Default M2 Settings

Post by jimc » Fri Apr 11, 2014 4:05 am

yes keith, in your process where the name of it is...."select profile", click the drop down arrows on the right then choose makergear m2

Posts: 1864
Joined: Thu Apr 10, 2014 4:00 am

Re: Default M2 Settings

Post by jsc » Fri Apr 11, 2014 4:24 am

If you already have the MakerGear M2 profile selected, select a different one at random, and then go back to it. If you have saved your settings as MakerGear M2, you can differentiate the stock settings vs. your exported setting because the stock settings do not have ".fff" in the drop down.

Post Reply