S3D Issues with new M2
- pcenginefx
- Posts: 55
- Joined: Wed Dec 17, 2014 10:02 pm
Re: S3D Issues with new M2
Just an update..........I changed the FW to RepRap and it is preheating now automatically.
//Aaron
3D Print Services | www.3dhubs.com/seattle/hubs/aaron
3D Print Services | www.3dhubs.com/seattle/hubs/aaron
Re: S3D Issues with new M2
pcenginefx,
I'm not at my machine right now, so I can't check. But if there's a selection for "Marlin" firmware, that's the best one to use. RepRap would be the choice if Marlin in not available.
Dale
I'm not at my machine right now, so I can't check. But if there's a selection for "Marlin" firmware, that's the best one to use. RepRap would be the choice if Marlin in not available.
Dale
Re: S3D Issues with new M2
"RepRap (Marlin/Repetier/Sprinter)" is the label.
- pcenginefx
- Posts: 55
- Joined: Wed Dec 17, 2014 10:02 pm
Re: S3D Issues with new M2
Yep, choosing the "RepRap (Marlin/Repetier/Sprinter)" option fixed my current problem. Thank you all for helping fix my issue!
//Aaron
3D Print Services | www.3dhubs.com/seattle/hubs/aaron
3D Print Services | www.3dhubs.com/seattle/hubs/aaron