Simplify 3d

Have questions or comments about Simplify3D, Slic3r, Cura, Reptier, etc? Or wondering about which CAD software to use...discuss it here...
Post Reply
User avatar
PcS
Posts: 667
Joined: Mon Mar 09, 2015 12:19 pm
Location: Michigan

Simplify 3d

Post by PcS » Sun May 31, 2015 5:56 pm

Just found this page today after pulling my hair out with the black and white petg constantly jamming. Thought it would be useful as I found it clarified a LOT of things I thought I knew !!! lol :D http://forum.simplify3d.com/viewtopic.php?f=8&t=2367
Top
User avatar
jimc
Posts: 2888
Joined: Wed Apr 09, 2014 11:30 pm
Location: mullica, nj
Contact:
Contact jimc

Re: Simplify 3d

Post by jimc » Sun May 31, 2015 7:36 pm

yeah kw did a good job of putting that together a couple months ago. did you get your jamming situation under control?
Top
User avatar
PcS
Posts: 667
Joined: Mon Mar 09, 2015 12:19 pm
Location: Michigan

Re: Simplify 3d

Post by PcS » Sun May 31, 2015 11:07 pm

It so far....fingers crossed has made it 6 hrs into a 50 hr print. I hope I have. The stuff just gets anything on the nozzle with long infill and long solid runs and it snowballs to a jam inducing clump. Looking clean so far.
Top
Post Reply

Return to “Software”