This is peeling the support off of a HIPS print, done at 0.2mm layer height. The side support isn't too special, it was just a precaution, since the part was only about 45 degrees there. But, look at the support on the bottom.
https://goo.gl/photos/9LUUNicmZE5DqrUNA
This isn't an M2, but it works just as well on an M2. This is my ONI. My M2s are all busier with more important and less photographable prints
Anyone on the fence about buying S3D?
Anyone on the fence about buying S3D?
Custom 3D printing for you or your business -- quote [at] pingring.org
Re: Anyone on the fence about buying S3D?
I have to agree - if S3D did nothing else but the support - it would be worth the money.
Secondly - as an Australian I applaud the casual way the abuse was delivered at the end of the clip ... Nice
Secondly - as an Australian I applaud the casual way the abuse was delivered at the end of the clip ... Nice