Have questions or comments about Simplify3D, Slic3r, Cura, Reptier, etc? Or wondering about which CAD software to use...discuss it here...
-
insta
- Posts: 2007
- Joined: Tue Sep 16, 2014 3:59 am
Post
by insta » Sun Jun 19, 2016 5:36 pm
zemlin wrote:insta wrote: I had the bed at 135C. It ... was not an easy task.
Did you heat it in a box? (Sam I am)
Yes, actually. The entire printer was enclosed in cardboard draped with oil-soaked rags for extra flammability.
(I'm actually serious about the cardboard)
Custom 3D printing for you or your business -- quote [at] pingring.org