Simplify3D - Support defaults

Have questions or comments about Simplify3D, Slic3r, Cura, Reptier, etc? Or wondering about which CAD software to use...discuss it here...
Post Reply
User avatar
AndyB
Posts: 38
Joined: Sat Jun 18, 2016 3:20 pm
Location: Los Altos, California

Simplify3D - Support defaults

Post by AndyB » Mon Jul 04, 2016 4:51 pm

Hello,

I currently have these settings for the supports:
pic001.jpg
I would like to put it back to defaults settings, can someone please provide a screen shot of the defaults.

Thank you.

User avatar
Jules
Posts: 3144
Joined: Wed Jan 21, 2015 1:36 am

Re: Simplify3D - Support defaults

Post by Jules » Mon Jul 04, 2016 6:17 pm

You see that Profile Title up at the top that says MakerGear M2 (24V V4 hotend) (modified)? Just click the dropdown arrow next to it and choose another profile without saving that one first, and it will revert to the last saved settings the next time you open the MakeGear M2 profile.

Those settings are going to go away permanently unless you save them under a new name (Save as New) before you switch back to the original default values.

User avatar
AndyB
Posts: 38
Joined: Sat Jun 18, 2016 3:20 pm
Location: Los Altos, California

Re: Simplify3D - Support defaults

Post by AndyB » Mon Jul 04, 2016 9:22 pm

Thank you, Jules.

I didn't see the selection of Default when I clicked the 'Select Profile' down arrow.

Post Reply