Anyone had success with the Craftware Slicer?
Posted: Fri Jul 08, 2016 1:38 pm
I have the free 1.14 beta playing around with it, but I'm having trouble digesting how it handles retractions.
It has settings under "travel" that are retractions, but I'm not sure about the "prime" length. I tried the settings shown (the prime is set to 1.6 mm, hard to see in their colors), and I got a lot of ooze between travels. I wouldn't think prime would affect stringing.
Anyhow- if anyone has figured out some good "M2 friendly" settings, please share
It has settings under "travel" that are retractions, but I'm not sure about the "prime" length. I tried the settings shown (the prime is set to 1.6 mm, hard to see in their colors), and I got a lot of ooze between travels. I wouldn't think prime would affect stringing.
Anyhow- if anyone has figured out some good "M2 friendly" settings, please share