What's wrong with this print?

Have questions or comments about Simplify3D, Slic3r, Cura, Reptier, etc? Or wondering about which CAD software to use...discuss it here...
13brv3
Posts: 9
Joined: Thu May 29, 2014 1:47 pm

Re: What's wrong with this print?

Post by 13brv3 » Mon Nov 28, 2016 3:25 pm

quentinthornton wrote:Thanks!! I finally got it now! I ended up putting my extrusion multiplier to 115%.
Hmmmm, just noticed your post 13brv3. I'll see if it helps at all, and I'll reply back if it does.
You didn't miss it. There was delay in the post appearing because I'm new to the forum, though not new to my 2013 printer. I guess I'm being "moderated" :lol:

Good luck with it.
Rusty

Post Reply