Have questions or comments about Simplify3D, Slic3r, Cura, Reptier, etc? Or wondering about which CAD software to use...discuss it here...
3 posts • Page 1 of 1
I know a lot of us here use Octoprint and I have stumbled onto a plugin that I have found useful and thought I would share. It lets you edit your eeprom settings inside of Octoprint and permanently save them. I have found this to be a huge time saver in adjusting settings. It can be found HERE
I can vouch for that plugin as I use it all the time. The only tricky part is you have to click the save button above the form, not the enticing blue save button at the bottom (silly me going for big blue buttons).
Installed the plug as soon as i saw the message here. It's been very useful while I've been working on dialing in my print settings. Thanks for the tip.