Page 1 of 1

stringing with the standard settings

PostPosted: Wed Jan 10, 2018 5:13 pm
by Mazhdulin
Hi all,

I performed the CTRLV V3 test for the M3ID and the issue I encountered most is stringing,
Now I know I should fiddle with the retraction settings, but as I'm really new I don't know how much or which settings.
I'm using al the basic settings and PLA from makergear. 0.1mm layers. speed 50mm/s or 100mm/s not much difference there.
Can someone give an me a headstart based on the pictures of the part?:

20180109_133826.jpg

20180109_133917.jpg

20180109_133926.jpg

Re: stringing with the standard settings

PostPosted: Wed Jan 10, 2018 7:18 pm
by sthone
Even if you do not use S3D this is a great guide for learning how to fix all the issues that may arise ... https://www.simplify3d.com/support/prin ... eshooting/