M3ID create the dual color keychain using simplify3d

Have questions or comments about Simplify3D, Slic3r, Cura, Reptier, etc? Or wondering about which CAD software to use...discuss it here...
Post Reply
benadamspears
Posts: 3
Joined: Tue Jul 31, 2018 2:23 pm

M3ID create the dual color keychain using simplify3d

Post by benadamspears » Tue Jul 31, 2018 2:29 pm

I'm currently using a M3ID and simplify 3d and a host of different CAD software (tinkercad, Autocad) and I want to create a part similar to the dual color keychain that has 2 colors one inside the other but I am unsure how its done? I have read through Simplify 3d's forum and how to guide and I have not found anything that would apply. I have also tried looking into the Gcode of the dual color keychain but I have not found anything that I could use.

Any thoughts or even a point in the direction of a guide that would help would be appreciated.

Thanks!

TerryL
Posts: 10
Joined: Wed Jun 07, 2017 1:47 am
Location: Wisconsin, USA

Re: M3ID create the dual color keychain using simplify3d

Post by TerryL » Tue Jul 31, 2018 5:08 pm

Have you seen this? I'm not sure if it is what you are looking for.

https://makergear.zendesk.com/hc/en-us/ ... Simplify3D

Post Reply