Ok so using some sort of warp technology Makergear got the kit to me today- Thats the good news.
Ok so now onto the not so good news.
1) The positioning of the sensor is going to directly conflict with the side mounted fan for the E3D mount that most people are using (assuming most people are using Jims version from thingiverse). A potential work around may be to remove the fan when the sensor is in place. Another option might be to create a mount that clips into the side mounting mechanism that Jim has developed. I would leave that to him to decide on as I don't have the original model. The current setup is basically an L bracket that screws to a new flat surface on the motor mount.
2) When you said the instructions were minimal, I was prepared for a basic diagram. What I wasn't prepared for was a complete lack of any wiring diagram etc. So yeah I can mount the sensor but what do you want me to hook it up to. I am assuming given the length of the wiring it needs to go to the rambo itself, but where - I am looking at a diagram of the M2 rambo from your website. Just direct me where to plug.
3) How far down do I mount the probe in the bracket.
I consider myself fairly handy but you gotta give me something slightly more than a single diagram showing the parts. That's not minimal instructions its positively anorexic
