problem in printing
Re: problem in printing
I did use any other material then PLA the screw are OK . I try to print with a new PLA roll that I take out from pack and has a anti humidity material little beg in and get the some result as you can see in picture some of print is nice and some is like points
Doron Berezovitz
doronberezovitz1@gmail.com
doronberezovitz1@gmail.com
Re: problem in printing
That looks like a really low spot in the bed, with a serious over-extrusion situation. (Air printing on one side - might be a level problem.)
Did you change the plate for a different one?
Is your bed still level?
viewtopic.php?f=3&t=2783
Have you checked the gap lately (to see if it is still small enough) by running the calibration for height?
viewtopic.php?f=3&t=3124
Did you change the plate for a different one?
Is your bed still level?
viewtopic.php?f=3&t=2783
Have you checked the gap lately (to see if it is still small enough) by running the calibration for height?
viewtopic.php?f=3&t=3124
Re: problem in printing
Hi guys
It was a problem of leveling ans Z endstop .Thanks for help
It was a problem of leveling ans Z endstop .Thanks for help
Doron Berezovitz
doronberezovitz1@gmail.com
doronberezovitz1@gmail.com