Just received my first spool of Taulman Allow 910. Would anyone be kind enough to share their profile?
Thank you!
Taulman Alloy 910 Profile?
Re: Taulman Alloy 910 Profile?
I am working on my setup for Alloy 910 as well. I am off to a pretty good start but sill have adjustments to make. Will share when its solid.
Re: Taulman Alloy 910 Profile?
I am impressed with Taulman's Alloy 910. Bed adhesion is excellent; PEI with PVA glue stick, 45°C bed temp. Prints are clean, minimal stringing, virtually no start/stop discontinuities. Printing at 260°C extruder temp with a V3; be advised I have checked my extruder temp with a thermocouple inserted in the heater block temp well and know it runs 8°F cooler than the control set point. I have attached a photo of a turbine wheel printed with these setting. Note that I have not optimized the bridging properties. I am starting with the settings given by jules for PETG.
- Attachments
-
- Taulman_910_Fine.fff
- FFF for Taulman Alloy 910, 0.2mm layer height
- (9.77 KiB) Downloaded 627 times
-
- Posts: 59
- Joined: Mon Mar 21, 2016 2:18 am
Re: Taulman Alloy 910 Profile?
Thanks quaver, I appreciate it!
-
- Posts: 1
- Joined: Tue Jan 02, 2018 7:37 am
Re: Taulman Alloy 910 Profile?
I am working on my setup for Alloy 910 as well.
Re: Taulman Alloy 910 Profile?
This thread had been a good repository of filament success, (and some failure). viewtopic.php?f=11&t=1951&start=20
Please post to there as well and add any filament not already mentioned that you use.
Please post to there as well and add any filament not already mentioned that you use.