MIC6/PEI - ABS Not Sticking
Re: MIC6/PEI - ABS Not Sticking
You're sure it's heating? (Might have to try some hairspray or gluestick. It should stick to the PEI unless you got oils on it.)
Re: MIC6/PEI - ABS Not Sticking
The bed is heating. I can hardly touch it.
Re: MIC6/PEI - ABS Not Sticking
I am going to let it cool down then give it a wiping with some IPA.
Re: MIC6/PEI - ABS Not Sticking
I went over the MIC6/PEI with the 1000 grit sand paper again and then wiped it down with a damp paper towel, dried it and then with some IPA. I set the Z Adjust height to make sure my first layer has some force/squish into the bed. PLA is adhering well. Will try ABS again here in a few.
Re: MIC6/PEI - ABS Not Sticking
Seems to be sticking well now. Must have been a film of oil or something preventing adhesion. Thanks to all for the help!
Re: MIC6/PEI - ABS Not Sticking
Man, this sounds like a problem. keep me posted as well! im interested in your result