Show off your prints!!!
- Posts: 1116
- Joined: Fri Apr 11, 2014 5:34 pm
- Location: Halfway up the Hudson
Quark wrote:a single pass starting on the inside and ending on the outside
That doesn't sound right: each layer should have a single closed perimeter thread outlining the whole radiator shape. If the fins are smaller than the extrusion width, then the slicer may suffer a brain cramp and do silly things, but … those short thread snippets may also indicate a non-manifold model triggering bizarre slicing results that almost
its a little beat up
Hey, it's supposed
to look like that! [grin] Nice detailing!