(BTW, I know the temperatures are off for PLA printing, but I reverted back to my ABS slic3r configuration because it was working just an hour before and I was trying to isolate the number of things I changed to figure out where things went awry)
Code: Select all
; generated by Slic3r 1.2.9 on 2017-05-23 at 21:58:06
; external perimeters extrusion width = 0.35mm
; perimeters extrusion width = 0.59mm
; infill extrusion width = 0.98mm
; solid infill extrusion width = 0.59mm
; top infill extrusion width = 0.59mm
M107
M190 S80 ; set bed temperature
M104 S230 ; set temperature
G28 ; home all axes
G1 Z5 F5000 ; lift nozzle
M109 S230 ; wait for temperature to be reached
G21 ; set units to millimeters
G90 ; use absolute coordinates
M82 ; use absolute distances for extrusion
G92 E0
G1 Z0.350 F7800.000
G1 E-2.00000 F2400.00000
G92 E0
G1 X86.668 Y109.274 F7800.000
G1 E2.00000 F2400.00000
G1 X88.820 Y108.481 E2.19812 F1800.000
G1 X90.000 Y108.375 E2.30044
G1 X110.000 Y108.375 E4.02810
G1 X112.259 Y108.772 E4.22622
G1 X114.247 Y109.915 E4.42433 F1800.000
G1 X115.726 Y111.668 E4.62245
G1 X116.519 Y113.820 E4.82056
G1 X116.625 Y115.000 E4.92289
G1 X116.625 Y135.000 E6.65055
G1 X116.228 Y137.259 E6.84866