Hi Community,
I'm having a heck of a time finding a vendor for a MIC6/PEI plate cut for M2. I'm sure this has been covered a million times, but I don't see anything too recent on the forums.
Thanks for the assist!
Vendors selling MIC6/PEI specifically sized for M2.
Re: Vendors selling MIC6/PEI specifically sized for M2.
I have one left.
Custom 3D printing for you or your business -- quote [at] pingring.org
Re: Vendors selling MIC6/PEI specifically sized for M2.
Cool, how do I get one?
If you only have one left, do you have a recommended vendor out there for additional?
If you only have one left, do you have a recommended vendor out there for additional?
Re: Vendors selling MIC6/PEI specifically sized for M2.
If you're ok with a used one with some PETG stuck to it that I can't get off, I have two left
Nobody else makes them, as far as I know. It's not *hard*, it just requires the right tooling, and to be cost / time effective you have to make like 20 at once.
Every now and then I'll make another batch of them when interest gets high enough.
Just email me -- email's in the signature.
Nobody else makes them, as far as I know. It's not *hard*, it just requires the right tooling, and to be cost / time effective you have to make like 20 at once.
Every now and then I'll make another batch of them when interest gets high enough.
Just email me -- email's in the signature.
Custom 3D printing for you or your business -- quote [at] pingring.org