Heat Set Insert for Ikea Camera Mount

[CCRN]

I am printing Steve's ikea camera mount from thingiverse.

https://www.thingiverse.com/thing:1691549

I am not familiar with heat set inserts or where to get them locally. Fastenal?

Thanks,

Jerold

[Hugs]

I am not familiar with heat set inserts or where to get them locally. Fastenal?

McMaster-Carr has them. The heating irons and tips are on the right-hand columns of each size.

[ednisley]

heat set inserts or where to get them locally

Although they're intended for heat or ultrasonic setting, that requires far more precision / equipment / fussing than seems reasonable. I make the hole a snug fit for the insert's OD, butter it up with epoxy, and shove it in place.

Works like a charm:
https://softsolder.com/2017/04/28/badge ... eel-mount/



Get 'em from Amazon in two days or from eBay in two weeks. Search for (knurled brass insert) and away you go.

Some measurements and observations on eBay inserts:
https://softsolder.com/2016/02/03/knurl ... c-inserts/
https://softsolder.com/2016/02/16/knurled-inch-inserts/

[sthone]

I get my heat set inserts from Mcmaster.

Just a heads Up.... If you're going to print that just double check the light you have both of of mine have a tapered base pieces at the bulb head where my mount clamps on but I've been told some lights have a straight piece there so it might not work.



-Steve

[CCRN]

Ok, Amazon is great. Now I just have to figure out the size I need. Steve wrote on thingiverse he used 2/56" screws. The female end where it would go measures 3mm wide by roughly 5mm deep.

I am thinking this one would be about right and would love some confirmation before I order.

https://www.amazon.com/uxcell-M2x4mm-Em ... rt+m2+x4mm


Thanks,

Jerold

[CCRN]

I get my heat set inserts from Mcmaster.

Just a heads Up.... If you're going to print that just double check the light you have both of of mine have a tapered base pieces at the bulb head where my mount clamps on but I've been told some lights have a straight piece there so it might not work.



-Steve

My light has the taper in it. Which item should I order from McMaster? There is a lot there.

[sthone]

Here's the Specs to the ones I used.

[CCRN]

Here's the Specs to the ones I used.

Thanks. That helps me.

[CCRN]

Steve,

Would this screw work in the inset you spec'd?

https://www.mcmaster.com/#92200a077/=185jboq

[CCRN]

Looks like the "Thread Fit" spec is different.