strange print
strange print
Hi guys
I got 2 questions referring 2 pics attached
1) what is the case of some waves shown in print ?
2) the wires that are printed on bottom side of the print ( i use raft in the print )
Regards Doron
I got 2 questions referring 2 pics attached
1) what is the case of some waves shown in print ?
2) the wires that are printed on bottom side of the print ( i use raft in the print )
Regards Doron
Re: strange print
All of the surfaces and perimeter threads look like crap, so I'd check for an extrusion problem.
Have you calibrated the slicer's Extrusion Multiplier with the actual filament diameter and measured thin-wall square thickness?
Is the filament drive gear securely mounted on its shaft? A loose gear can cause baffling retraction problems, but the intermittent globs suggest there's something wrong with the drive.
Is the motor pinion driving the gearbox worn to a frazzle? You must dismount the gearbox from the motor to check, so do that when you check the drive gear.
If all that checks out, then some other problem may be in play, but it sure looks like extrusion from here.
Re: strange print
thanks
will check and see
Doron
will check and see
Doron
Re: strange print
Hi
checked slicer's Extrusion Multiplier with the actual filament diameter and measured thin-wall square thickness and got the almost the some results for all walls (+-0.5 mm) is it good or not ?
Disassemble into parts the extruder motor I don't find any problem i attach pictures maybe you can see something I don't notice
Thanks ahead Doron
checked slicer's Extrusion Multiplier with the actual filament diameter and measured thin-wall square thickness and got the almost the some results for all walls (+-0.5 mm) is it good or not ?
Disassemble into parts the extruder motor I don't find any problem i attach pictures maybe you can see something I don't notice
Thanks ahead Doron
Re: strange print
of course I mean +- 0.05 mm and not 0.5 mm (
Doron
Doron
Re: strange print
I typically get +/- 0.01 mm on my cal cube walls once I have the extrusion multiplier set right. The first wall thickness can often be off a little depending on retraction settings & the like, but 3 out of 4 should be pretty spot on.
Re: strange print
I typically get +/- 0.01 mm on my cal cube walls once I have the extrusion multiplier set right. The first wall thickness can often be off a little depending on retraction settings & the like, but 3 out of 4 should be pretty spot on.
Re: strange print
Hi
Do you use Simplify software as your slicer . If yes can you send the profile you use
Thanks Doron
Do you use Simplify software as your slicer . If yes can you send the profile you use
Thanks Doron
Re: strange print
I use S3D, but I'm packing to go out of town for a week. I didn't see what brand, or material you are using. If you are printing ABS for example, I have no profiles for that because I don't use it. I mostly print with eSun PLA+, which requires a different profile from regular PLA.
If you tell us what you are using, maybe somebody else can provide a profile. You can also check out the filaments sub-forum.
If you tell us what you are using, maybe somebody else can provide a profile. You can also check out the filaments sub-forum.
Re: strange print
Hi
I am using HatchBox 1.75 mm PLA will like to get good profile for S3D printer
regards Doron
I am using HatchBox 1.75 mm PLA will like to get good profile for S3D printer
regards Doron