What are all the allen wrenches in the M2 toolset?

Ask your kit assembly questions here...
Post Reply
User avatar
insta
Posts: 2007
Joined: Tue Sep 16, 2014 3:59 am

What are all the allen wrenches in the M2 toolset?

Post by insta » Tue Oct 28, 2014 4:30 am

EVERY Allen wrench I own is in a big pile for some reason. I want to separate out the ones used on the M2 -- which ones should I set aside?
Custom 3D printing for you or your business -- quote [at] pingring.org

Dale Reed
Posts: 376
Joined: Thu Apr 10, 2014 1:39 am
Location: Cleveland Heights, Ohio USA

Re: What are all the allen wrenches in the M2 toolset?

Post by Dale Reed » Tue Oct 28, 2014 5:56 pm

Insta,

Perhaps the picture on page 6 of this document ( http://cdn.shopify.com/s/files/1/0030/7 ... ox.pdf?877 ) will help. (NOTE: the document shows the older dual-supply M2, with 12 volt and 19 volt bricks -- but aside from the new V3B hot end and the new single 24 volt supply, the document should be quite close. The tools on page 6 should be right on.)

I would guess the following: The M3 (I think it's 2.5 mm) hex driver, the M4 (I think it's 3 mm) hex driver, and the metric hex keys from about 1.5 to 5 mm or so should cover the M2 through M6 hardware used on the M2 printer.

But an e-mail to MakerGear support should result in a response with the definitive list of tools from their Bill of Materials...

Dale

Ronnien55
Posts: 60
Joined: Mon Dec 08, 2014 2:50 am
Location: Holly Springs NC

Re: What are all the allen wrenches in the M2 toolset?

Post by Ronnien55 » Wed Feb 18, 2015 4:36 am

Just a quick note, After looking at the picture of tools, of course i have had my M2 for a couple of months ,but I never received the M4 driver.

User avatar
insta
Posts: 2007
Joined: Tue Sep 16, 2014 3:59 am

Re: What are all the allen wrenches in the M2 toolset?

Post by insta » Wed Feb 18, 2015 6:49 am

Ronnien55 wrote:Just a quick note, After looking at the picture of tools, of course i have had my M2 for a couple of months ,but I never received the M4 driver.
I think they stopped sending that one after awhile. My second M2 from MG only had the M3 driver, but the full complement of allen wrenches.
Custom 3D printing for you or your business -- quote [at] pingring.org

Ronnien55
Posts: 60
Joined: Mon Dec 08, 2014 2:50 am
Location: Holly Springs NC

Re: What are all the allen wrenches in the M2 toolset?

Post by Ronnien55 » Sat Feb 21, 2015 8:09 pm

Thanks, I did have all the Allen wrenches as well.

Post Reply