Can't log into access point

Ask the MakerGear community for assistance...
Post Reply
kskiff7034
Posts: 7
Joined: Tue Jun 05, 2018 11:48 pm

Can't log into access point

Post by kskiff7034 » Tue Jun 05, 2018 11:52 pm

I just got my 3d printer today. I got it all set up and it was working great, but then I was trying to configure it for remote access and must have messed something up because my login information to octoprint wasn't working anymore. I used the re-set button and held it for 60 seconds, but now when I try to reconnect to the access point it doesn't display anything. I hooked up an ethernet cord and was trying to log into that, but when I enter the information that the setup thing tells me, it doesn't work. The window disappears for a second then pops right back up. Any help wuould be GREATLY appreciated.

kskiff7034
Posts: 7
Joined: Tue Jun 05, 2018 11:48 pm

Re: Can't log into access point

Post by kskiff7034 » Wed Jun 06, 2018 7:27 pm

I got this all fixed. I guess trying to set up remote access and tinkering with HAProxy on the raspberry pi messed something up. I SSH'd in and reverted it and it started working again.

Post Reply