I want to make a wire guide for the bed heater wires that changes the wire direction 90deg downward. The direction, going straight out the back is running into the enclosure I am building. Is there a model anywhere of the clamp for the wires that attaches at the back of the bed? I started measuring, but ran out of time today. So while I wait for some time tomorrow, I thought I would see if I could make my life easier by checking for a CAD model that I could just import and subtract from a block to get my basic model.
Sorry, I just noticed I may have posted on the wrong forum. If you would prefer this in the modifications forum, could you please move it?
Have a great day,
General discussion topics
2 posts • Page 1 of 1