Electronics Upgrade

Ask the MakerGear community for assistance...
Post Reply
mbonadio
Posts: 18
Joined: Tue Jun 24, 2014 7:14 pm

Electronics Upgrade

Post by mbonadio » Sun Aug 12, 2018 12:21 am

Hi All,

I've got one of the original M2's with an old LCD and over the years it's been upgraded so that now it's at Rev E. My only concern is that the Rambo board and LCD screen seem to be no longer supported as each time I've done an upgrade, support has built me a special version to support my configuration. I'd like to know if there is a way to go back to stock so I can grab the latest version of the code and not be special. My one pain point is that the SD card isn't recognised until I reset the board and I know this isn't an issue in the latest Rambo.

Thanks for the info

Cheers
Michael

Post Reply