Makergear cameo shot on youtube

General discussion topics
Post Reply
User avatar
willnewton
Posts: 464
Joined: Wed Apr 09, 2014 8:32 pm

Makergear cameo shot on youtube

Post by willnewton » Tue Apr 02, 2019 10:22 pm

Thomas Sanladerer interviewed Slice Engineering about the Mosquito Hotend at MRRF2019. They present it mounted on a MG printer. Nice!

https://www.youtube.com/watch?v=OIWaVJwuihY&t=335s
I'm finally back to where I started two days ago!

A thread with some stuff in it I update every once in a while. viewtopic.php?f=8&t=9
See some of my stuff http://www.thingiverse.com/willnewton/about

User avatar
rpollack
Posts: 477
Joined: Wed Apr 09, 2014 9:01 pm
Location: Beachwood, OH
Contact:

Re: Makergear cameo shot on youtube

Post by rpollack » Wed Apr 03, 2019 5:27 pm

Thanks for posting! Chris from Slice sent us a link to the video. I asked him to send us a hot-end to test...

Rick

jferguson
Posts: 148
Joined: Mon Mar 30, 2015 7:26 pm

Re: Makergear cameo shot on youtube

Post by jferguson » Mon May 20, 2019 6:07 pm

I may be mistaken, but it looks like the Mosquito Hot End is really intended for a bourden drive printer. I emailed these guys and learned that they couldn't mount their really slick heat-sink setup on the M2 because the filament drive was in the way. So they left it off.

My question then would be "Is there any reduction in the capabilities of your hot end system when it is incomplete?"

Post Reply