MakerGear M3 Independent Dual Extruder 3D Printer Rev 1

The place to discuss the M3-ID
Post Reply
Belezeebub
Posts: 1
Joined: Wed Jul 03, 2019 2:57 am

MakerGear M3 Independent Dual Extruder 3D Printer Rev 1

Post by Belezeebub » Wed Jul 03, 2019 3:18 am

I am looking to add a dual extruder printer to my farm I was thinking of Ultimaker 3/S5, raise 3d pro 2 or Taz pro but I found the MakerGear M3 Independent Dual Extruder 3D Printer - Rev 1 to be honest never heard if it and reviews are few and far between so I figured I would see what the users will say about it.

makeal
Posts: 73
Joined: Sat Aug 25, 2018 2:13 pm

Re: MakerGear M3 Independent Dual Extruder 3D Printer Rev 1

Post by makeal » Sun Aug 04, 2019 11:23 pm

Belezeebub wrote:
Wed Jul 03, 2019 3:18 am
I am looking to add a dual extruder printer to my farm I was thinking of Ultimaker 3/S5, raise 3d pro 2 or Taz pro but I found the MakerGear M3 Independent Dual Extruder 3D Printer - Rev 1 to be honest never heard if it and reviews are few and far between so I figured I would see what the users will say about it.
Ultimaker and M3-ID would be good choices. Ultimaker is 2.85mm diameter filament. M3-ID is a solid machine

Post Reply