Different looking v3b

Need some assistance getting started...post here...
Post Reply
bill_i_am
Posts: 6
Joined: Sun Nov 10, 2019 6:54 pm

Different looking v3b

Post by bill_i_am » Sun Nov 10, 2019 7:13 pm

Hi, I have a used M2 with no documentation. The v3b hot end it has (aside from being clogged) looks different than other v3b images I have found. Any ideas what the vintage is?
Three images https://imgur.com/a/ucHvHQf
BTW, The nozzle says MG .50

Thanks

User avatar
sthone
Posts: 892
Joined: Tue Jul 08, 2014 8:25 pm
Location: Connecticut
Contact:

Re: Different looking v3b

Post by sthone » Wed Nov 13, 2019 10:59 pm

Looks like a V3B to me but there were two revisions apparently. http://makergear.wikidot.com/m2-extruder
____________________________________________________
See my projects at https://www.theneverendingprojectslist.com

bill_i_am
Posts: 6
Joined: Sun Nov 10, 2019 6:54 pm

Re: Different looking v3b

Post by bill_i_am » Tue Jun 30, 2020 6:03 pm

Thanks for the reply! Back on the forum with another problem. I don't usually look at forum as I am such a noob that I don't feel I have much to contribute. I did end up putting on a V4b hotend along with a lot of other work. Someone had partially disassembled the M2!? Luckily Support was ultra supportive!

Post Reply