M3-ID Octoprint 'Still stabilizing'

Ask the MakerGear community for assistance...
Post Reply
jamesfletcher
Posts: 1
Joined: Sat Jun 27, 2020 10:31 am

M3-ID Octoprint 'Still stabilizing'

Post by jamesfletcher » Sat Jun 27, 2020 10:40 am

Hi there, I'm very new to this forum and just getting to grips with my M3-ID. up until now, I have had no real issues but I recently uploaded a simple model with Gcode created with Simplify 3D. I used an existing stl and scaled by 150% in S3D and uploaded to Octoprint.

When I begin printing this part, the state shows 'Still stabilizing...' (with a red dot). When I hover over the red dot, the following message appears: 'Based on linear approximation (very low accuracy, especially at the beginning of the print)'

The print is extremely slow and states 16 hours for a 2.6MB file.

Any advice would be amazing.

Thanks in advance

Post Reply