Sorry to hear such bad news.
Thanks to all the MakerGear Team for their support, and the very good products they design.
Could I do something to help you ?
Sincerely Yours

Hello,
I'm very happy with my M3 ID.
Recently I noticed that when T0 and T1 are "cold", the temperature displayed are clearly different (about 5 degrees).
Is it a way to adjust them ?
Thanks for your help

Hi, I recently updated my octoprint plugins. I know, it was a bad idea :-). Previously, I was a happy user of the octoprint curaEngine slicer. I prefer it to S3D for very simple objects, and for objects that require a raft. S3D tends to produce rafts difficult (nearly impossible) to remove. But it s...

would love a config for Cura 4.3 I also think it's kind of hard that Utimaker doesn't provide the M2 in a preset. Hi, Thanks for your job. I will be greatly interested by a Cura profile for my Makergear M3 ID. I'm using the Cura slicer included in Octoprint as much as possible, but it is clearly le...

Hello,
thanks for your answer.
Actually, I was looking for a way to move the motor (and adjust the belt tension) with the right strength.
Some 3D printers use an adjustment screw, other use a spring to have the right tension.
Thanks for your help.

Hello,
I'm the happy owner of a M3ID. Recently, the right X pulley begun to make noise when moving.
As the noise disappeard when I push on the belt, I think that should be more stretched.
Could you please explain how doing that.
Thanks
Best regards

Hi I installed my BL touch upgrade yesterday. Everything was fine, until I saw the hotend trying to print at 10cm above the bed. I stopped it, and saw this error message: "Recv: error detected bl touch set_bltouch_deployed1 Recv: Error: [002]-[11] Probe Deployment Error: Please restart your printer....

Hello,
thanks for your suggestion.
They answer with a piece of adive that solves the problem
Best regards

Hello, I was printing some mode, but things were going wrong... I decided to check the bed level, and reset the main M3 board. After that, the symptoms are: - at boot, the M3 emits only two notes instead of the whole boot set of notes. - the green led lights on, - the fan does not start, - the Octop...