Search found 2 matches
Search found 2 matches • Page 1 of 1
- Wed May 19, 2021 3:51 pm
- Forum: Getting Started
- Topic: slipping filament - motor shaft wiggly
- Replies: 7
- Views: 4811
The drive gear should not be wiggly right to left up and down. If it slips in and out tighten the set screw. I had to replace the roller bearing. The number is ~~~ Ball Bearings, 698RS Bearing Deep-Groove Ball Bearings 8 x 19 x 6mm / 0.3 × 0.7 × 0.2in Rubber Sealed Bearing https://www.amazon.com/gp/...
- Sun Feb 09, 2020 7:20 pm
- Forum: General Discussion
- Topic: Octoprint and M2 print Bed leveling
- Replies: 5
- Views: 7272
Zemlin The program that was referenced in this post works like your octoprint scripts. Except it saves the z start point http://forum.makergear.com/viewtopic.php?f=7&t=4762&p=38134#p38134 This gcode saves the z start point after reading it and then manually adjusting the number but I don't know how ...