Search found 28 matches
- Sat Jan 02, 2016 4:40 pm
- Forum: General Discussion
- Topic: Wattages!
- Replies: 6
- Views: 20663
Re: Wattages!
Any thoughts on what the hotend might be running at? believe i heard 40 watts some where before?
- Sat Jan 02, 2016 4:59 am
- Forum: General Discussion
- Topic: Wattages!
- Replies: 6
- Views: 20663
Re: Wattages!
Thanks, trying to set up the "Printer Stats" plugin on octoprint to help gauge power usage. Not sure how useful it will be unless it can somehow detect the usage itself
- Sat Jan 02, 2016 2:27 am
- Forum: General Discussion
- Topic: Wattages!
- Replies: 6
- Views: 20663
Wattages!
Anyone know the typical/average wattage of the M2 heated bed, hotend, stepper motors and the fans each individually?
- Sat Dec 26, 2015 10:01 pm
- Forum: Modifications
- Topic: PEI Bed Surface
- Replies: 161
- Views: 187878
Re: PEI Bed Surface
I had my 1/8" PEI sheet laminated to the bed and I had such a horribly uneven surface that I just flipped the glass over and forgot about it. One day I got bored and removed the sheet and instead of throwing it out I got bigger clips, gave the surface a good wet-sanding with 1000 grit and gave it a...
- Fri Dec 25, 2015 12:59 am
- Forum: Modifications
- Topic: PEI Bed Surface
- Replies: 161
- Views: 187878
Re: PEI Bed Surface
Ive not tried PEI at all just been doing my research and havent found anyone thats used over 1/8 sheets.. I noticed there is Ultem 2100- 2400 which is fiberglass reinforced PEI sheets in varying percentages that sound promising to prevent warping but i cannot find it sold anywhere with out emailing ...
- Thu Dec 24, 2015 12:33 pm
- Forum: Modifications
- Topic: Testers Needed
- Replies: 246
- Views: 240950
Re: Testers Needed
Are the rubber pads still apart of this "simplified" bed leveling? I hated those for the longest time until I chipped the corners off the glass and made new corner pieces to only hold down the heat plate. If I couldnt get the bed leveled with the 3 screws I figured out I could simply loosen/squeeze ...
- Thu Dec 24, 2015 11:43 am
- Forum: Modifications
- Topic: PEI Bed Surface
- Replies: 161
- Views: 187878
Re: PEI Bed Surface
Im considering getting a 1/8 or 1/4 inch sheet of PEI and just clipping it on the bed with larger clips... does anyone know if thicker sheets warp with the high temps of the bed? or do you go with thin sheets in hopes of getting it as flat as the glass? Sounds like there is an issue of getting good ...
- Thu Oct 15, 2015 8:47 am
- Forum: General Discussion
- Topic: Filament guide block cracked ordered V4 Hotend
- Replies: 7
- Views: 8566
Re: Filament guide block cracked ordered V4 Hotend
I had to redesign the v3b extruder to get it to print flexible filaments it just wasnt going to work reliably with their design. the v4 has been running non stop for the last several weeks printing TPU with very few failed prints. most of the failed prints were due my error or to clogged nozzles whi...