Search found 1205 matches
- Mon Dec 03, 2018 2:22 pm
- Forum: Printed Object Showcase
- Topic: M2 V4 Extruder Mod
- Replies: 8
- Views: 8177
Nice implementation! Thanks for the wiring diagram on the Thingiverse post. It is encouraging to see that it can be done without using any of the ports needed for the dual extruder. As I posted in my comment to your design on Thingiverse, I have an inductive sensor that I have not been particularly ...
- Mon Oct 08, 2018 1:34 pm
- Forum: Tech Support
- Topic: Why not update FW for M2 printers?
- Replies: 5
- Views: 5268
Mainly it's just a support headache for MakerGear. I am an open source software developer, so I know this routine very well: When you're dependent on someone else's software, they can change it at any time and break all your code. It's a fact of life in open source development. That doesn't mean it ...
Your statement about temp, is it possible to have each extruder at a different temp or does it have to do more with the 2 products interacting on the build plate? Yes and yes. Each part of a dual print is a completely separate set of gcode, and can have a different temperature, speed, extrusion rat...
(BTW---Your image appears as a broken link to me, and I assume to everyone) Stringiness and drippiness are not by-products of dual extrusion, but they sure do cause problems and mess up prints in ways that can't happen with a single-extrusion print. My main suggestion is to make sure that your two f...
- Tue Oct 02, 2018 3:16 pm
- Forum: General Discussion
- Topic: Introducing Ultra One
- Replies: 21
- Views: 14608
"Onboard Computer"? What's driving the Ultra-1? Sounds like it's got way more than a Rambo under the hood. And. . . do Kevlar-reinforced belts make a significant difference? That is, if I replaced my M2's belts with Kevlar-reinforced ones, would I expect to see any improvement?
- Tue Oct 02, 2018 3:06 pm
- Forum: Software
- Topic: Looking for a .fff file for a M2 Rev. D
- Replies: 3
- Views: 4800
I'm not sure what you mean by "outdated" in reference to Insta's files. They should be good for any M2 Rev. D or E; basically any M2 with a v4 extruder on it. I don't remember when MakerGear started the official revision letters, but I'm pretty sure it was well into the v4 era. As far as the FFF fil...