Search found 205 matches
- Wed Jan 30, 2019 4:15 pm
- Forum: General Discussion
- Topic: Simplify3D M2 Dual - Single Extruder Issue
- Replies: 3
- Views: 8410
Re: Simplify3D M2 Dual - Single Extruder Issue
I do not remember the name, but there was a previous thread that addressed this issue. I am sure you can find it by searching.
Re: Nylon
I print lots of nylon, including with a Markforged printer. The MF does not have a heated bed, but the prints stick well with glue stick. The bed is phenolic. I also use other nylons in it with differing success. Most work fine, but also string a lot, since the MF uses a 275C extruder temp. On the M...
- Wed Dec 19, 2018 9:08 pm
- Forum: Tech Support
- Topic: The Dreaded Filament Drive Clicking Sound...
- Replies: 3
- Views: 5795
Re: The Dreaded Filament Drive Clicking Sound...
The drive motor and gear are much harder/tougher than the plastic filament, so I do not think you can hurt them in that way. I have often heard the 'clunking' and have found it to be from the filament sticking in the extruder, the gear cuts a divot from the filament, and the compression and sudden r...
- Mon Nov 12, 2018 3:17 pm
- Forum: Filament
- Topic: burned(?) PETG in prints
- Replies: 7
- Views: 24476
Re: burned(?) PETG in prints
It is probably the issue discussed above, but it could possibly be in the filament before printing. I had an issue with this: IMG_0140.jpg It was several meters long in the middle of the 1 kg spool. The company immediately replace the filament, so I will not bad-mouth them. The burnt lumps were big ...
- Mon Nov 12, 2018 3:08 pm
- Forum: How-to/Guides/Tips
- Topic: First layer blistering when using PEI / BT
- Replies: 1
- Views: 14472
Re: First layer blistering when using PEI / BT
I have had similar problems when my bed was not clean enough. I have not used BuidTak, though...
- Tue Oct 23, 2018 4:44 pm
- Forum: Filament
- Topic: Need Flexible Filament advice
- Replies: 11
- Views: 42674
Re: Need Flexible Filament advice
Great idea! I will have to use that!
- Thu Oct 04, 2018 2:23 pm
- Forum: Tech Support
- Topic: changing extruder temps in official M3-ID .fff profile
- Replies: 3
- Views: 5805
Re: changing extruder temps in official M3-ID .fff profile
Did you try saving it as a new file?
- Mon Oct 01, 2018 5:03 pm
- Forum: Tech Support
- Topic: Simplify 3d fff settings
- Replies: 9
- Views: 12468
Re: Simplify 3d fff settings
Jules put up a pretty good file quite some time ago. I think it was in a thread titled "Black eSun PETG..." I am sure you can find it; lots of other good stuff in the thread, too. It should make a good start point at any rate.
- Tue Sep 04, 2018 10:14 pm
- Forum: General Discussion
- Topic: Introducing Ultra One
- Replies: 21
- Views: 64472
Re: Introducing Ultra One
Will you be at IMTS?
- Tue Sep 04, 2018 10:11 pm
- Forum: General Discussion
- Topic: Introducing Ultra One
- Replies: 21
- Views: 64472
Re: Introducing Ultra One
It is "component", not "componant".