Search found 12 matches
- Thu Apr 28, 2016 1:10 am
- Forum: Getting Started
- Topic: Rev. E using Simplify3D
- Replies: 3
- Views: 9000
Re: Rev. E using Simplify3D
Thanks. Did all suggestions except for roughing up the surface. Much better results now. Suspect once I rough the surface should be good-to-go, unless the design is not feasible for printing.
- Wed Apr 27, 2016 3:04 pm
- Forum: Getting Started
- Topic: Rev. E using Simplify3D
- Replies: 3
- Views: 9000
Rev. E using Simplify3D
Hello! OK I'm new to printing (sigh). I went through the bed calibration using the included startup software. The bracelet printed flawlessly. I then took a model of my own design, prepared is using Simplify3D, then printed it using all default configurations via the SD card route. That part also pr...