try again... permissions, permissions

I added a Kit Assembly section - please post questions about assembling kits in that section. Thank you.

@dryeti the nozzles are slightly different and we only 0.35mm at this time.

Regarding the release date, we previously indicated the dual extruder would be released before summer. Have not quite met that but it is in process... Here is the list of parts included in the upgrade: v4 hot ends (one metal, one w/ptfe insert) hot-end mount (machined) motor bracket (machined) filam...

Since there are two versions of the v4 (all-metal and ptfe liner) should we send out one of each with the upgrade?

Tim - I will be able to post that tomorrow.

A clearance page was added to the website today. Currently it has a few lightly used M2s and imperfect borosilicate. We have a lot of parts that either we are no longer using or can't use due to a defect so I expect we'll be adding to the page.

The dual extruder upgrade is now available for pre-order on the M2 upgrade page. Thank you.

The forum is getting swamped with spam that is primarily asian in origin. I am not sure how it gets past the spam prevention but there are pages of it each day in the moderation folder. Any suggestions on how to block this?

We are in the process of doing a short run of dual extruder upgrade components. This is limited to M2 owners and will cost $199. I do not have a specific ship date but it should be within a couple of weeks. Also, there are two versions of the new V4 hot-end, an all-metal version and a version that u...