Single v4 drive with filament tube guide
Single v4 drive with filament tube guide
When I was working on my "twin extruder" project, I pulled the standard v4 single filament drive off of the MakerGear github site, and found that it doesn't have a socket to hold the filament guide tube in place. Some posts indicated that such a thing exists and is being shipped on new M2s; however, it's not on the github site. Until it shows up there, here is an STL file of a filament guide with a holder for the guide tube that I designed by sucking the github STL into openSCAD and manipulating it. I hope it can be helpful to someone, or at least prompt the MakerGear guys into updating the github site. . .
- Attachments
-
- single_drive_with_guide.zip
- Single v4 filament drive with guide tube socket (zipped STL file)
- (383.14 KiB) Downloaded 478 times