Runout sensor

The place to discuss your hardware and software/firmware modifications...
agriff
Posts: 2
Joined: Fri Jul 29, 2016 10:09 pm

Re: Runout sensor

Post by agriff » Tue Sep 08, 2020 7:56 pm

Hi, First, I've been a low-key stalker of this forum since 2016. You've dropped so many good tricks and tips over the years, so thanks for that!

Anyway, I know this is an old post, but I just found it and, if possible, I would like to know/see your set-up w/ this upgrade... or at least where you found the info you needed to do it. I have the REV. E, since the REV. E came out and I'm just starting to upgrade it... I just put the new cooling system on it, the spool system, and now for a filament sensor. I would really appreciate it if you could help me out with that!

Also, I know you posted a few years ago about some kind of metal build plates but I can't find it and was hoping you could point me in that direction.

Thanks in advance for any help you can give!
Aaron

Post Reply