Flexible Magnetic Print System for Maker Gear

The place to discuss your hardware and software/firmware modifications...
Post Reply
Posts: 1
Joined: Mon Aug 12, 2019 6:38 pm

Flexible Magnetic Print System for Maker Gear

Post by klcjr » Mon Aug 12, 2019 6:42 pm

Hello, a forum member from the Railcore discord group who also owns a M2 suggested we post about our USA made flex plate system that we are now selling. We are a small startup that believes in producing top notch products while keeping manufacturing jobs here in the states.

We have MakerGear blank steel plates and magnets in stock and will be taking orders for PEI powder coated plates in the near future!


Posts: 77
Joined: Sat Aug 25, 2018 2:13 pm

Re: Flexible Magnetic Print System for Maker Gear

Post by makeal » Fri Aug 23, 2019 4:57 pm

I'm using Subtle design powder coated PEI and blank sheet on another printer. Blank plate I have paired with garolite surface. Just got it recently and about to start using it.
Powder coated PEI i had for about 3 months as a beta tester and it works great. Very good magnet holding. No shifting during printing. It will work great with Mic6 custom beds that some people use here. Or you can use the magnet base that comes with this.

Any questions , please ask

Post Reply