runout switch

The place to discuss your hardware and software/firmware modifications...
Post Reply
sonra
Posts: 116
Joined: Sat Aug 22, 2015 3:44 pm
Location: Israel

runout switch

Post by sonra » Wed Jul 29, 2020 7:06 pm

Hi guys
I try to use the runout switch so I can use my filament till end so i got the hardware when I try to modify the Marlin software I notice that I can not use the M600 command to pause the print because ( to my opinion ) i have an old Marlin ver that don't support it ( try to dig in the software )
My printer is M2 i don't know what revision but as i find in the MakerGear site it use ver called "M2Marlin-01-14-2016-OriginalZMotor"
Do you know if I am right and what can I do about , modify the current software or use newer ver ?
Regards Doron

Post Reply