Retract/Extrude mixed on Tool-1

The official subforum for discussion of the installation and use of the official M2 Dual Extruder upgrade.
Post Reply
scampa123
Posts: 195
Joined: Mon May 18, 2015 4:00 pm

Retract/Extrude mixed on Tool-1

Post by scampa123 » Sat Mar 05, 2016 6:52 pm

I just setup my dual and was starting to load the filament...I noticed my Tool-1 extruder is extruding when I tell it to retract!

Is this just a wire reversed or something?? How can I fix this?

Thanks!!
Top
scampa123
Posts: 195
Joined: Mon May 18, 2015 4:00 pm

Re: Retract/Extrude mixed on Tool-1

Post by scampa123 » Sat Mar 05, 2016 6:56 pm

I just found this post and will give it a try!

viewtopic.php?f=13&t=3150
Top
scampa123
Posts: 195
Joined: Mon May 18, 2015 4:00 pm

Re: Retract/Extrude mixed on Tool-1

Post by scampa123 » Sat Mar 05, 2016 8:37 pm

Yup that fixed it!
Top
Post Reply

Return to “M2 Dual Extruder”