Which Firmware for this??

The official subforum for discussion of the installation and use of the official M2 Dual Extruder upgrade.
Post Reply
daveb
Posts: 22
Joined: Tue Nov 03, 2015 4:06 am

Which Firmware for this??

Post by daveb » Tue Jun 06, 2017 3:16 am

Haven't used my printer since having to replace the Rambo board. When I did, I also added the Dual upgrade, and bottom Z-Stop and I have the Silver (older style) z-stop motor. . Bit confused on which firmware I should be using. I see a firmware for a system upgraded with 4 point leveling and z-stop upgrade, but no mention of duals. Then the one for a 24v silver motor with duals, but old style leveling.

thunderbt3
Posts: 105
Joined: Wed Apr 09, 2014 11:36 pm

Re: Which Firmware for this??

Post by thunderbt3 » Tue Jun 06, 2017 2:11 pm

I would ping MG's tech support to see if they can send you firmware configured for your system.

Post Reply