Octoprint module SD card access?

The place to discuss the M3-ID
paynterf
Posts: 29
Joined: Wed Sep 25, 2019 2:42 am

Re: Octoprint module SD card access?

Post by paynterf » Wed Jul 08, 2020 9:51 pm

I'
We here at MakerGear are actively working on updating the OctoPrint version for our M3 printers and we can't wait for you to try it out!
If the update is going to happen in some realistic time frame (not 'RSN'), I'll be happy to wait and try it out.

Frank

Deduin42
Posts: 6
Joined: Wed Jan 09, 2019 2:07 am

Re: Octoprint module SD card access?

Post by Deduin42 » Tue Jan 26, 2021 1:53 pm

I've been waiting for a MakerGear forked Octoprint new release for over two years (see my thread in the software forum). 1.3.6 can't run several plugins that I want to install for improvements to our printing processes.

Deduin42
Posts: 6
Joined: Wed Jan 09, 2019 2:07 am

Re: Octoprint module SD card access?

Post by Deduin42 » Tue Jan 26, 2021 1:54 pm

I've been waiting for a MakerGear forked Octoprint new release for over two years (see my thread in the software forum). 1.3.6 can't run several plugins that I want to install for improvements to our printing processes.

MaineSpring
Posts: 3
Joined: Thu Sep 16, 2021 1:51 pm

Re: Octoprint module SD card access?

Post by MaineSpring » Fri Oct 08, 2021 4:09 pm

Deduin42 wrote:
Tue Jan 26, 2021 1:54 pm
I've been waiting for a MakerGear forked Octoprint new release for over two years (see my thread in the software forum). 1.3.6 can't run several plugins that I want to install for improvements to our printing processes.
Hmmm. That's not what I was hoping to hear. I arrived here on a quest to find a way to update MG Octoprint or at least be able to use my plugins. :(

Post Reply