Startup Ooze Wipe
Posted: Wed Jun 09, 2021 2:29 pm
Hi. I just upgraded from an M2 Rev.E to the M3 ID. On my M2 just before the print started, the print head would move off the print plate and extrude for about 5-10 seconds, wipe against the edge of the plate, then start printing.
On the M3 ID, instead of extruding into thin air, it prints a line for each print head along the front edge of the X axis. This is fine except that I have a long print job and I need to move this wipe process to occur along the Y axis or in the same manner as the M2 as the current X axis wipe interfered with my print job.
Help?
On the M3 ID, instead of extruding into thin air, it prints a line for each print head along the front edge of the X axis. This is fine except that I have a long print job and I need to move this wipe process to occur along the Y axis or in the same manner as the M2 as the current X axis wipe interfered with my print job.
Help?