2nd Extruder z-height calibration

The place to discuss the M3-ID
Post Reply
Sensei
Posts: 12
Joined: Wed Apr 27, 2016 2:51 pm

2nd Extruder z-height calibration

Post by Sensei » Mon Sep 20, 2021 5:26 pm

I cannot seem to find documentation that explains how to calibrate the Tool 1 z axis. When I try to dual print, the right (Tool 1) is too high, and will not print properly (blobs up on head instead of adhering to surface). I assume a mechanical calibration is required, but would like to use a proven method vs doing this manually and risking to crack my print plate or damage the hot end.

ibash
Posts: 9
Joined: Wed Sep 08, 2021 8:37 am

Re: 2nd Extruder z-height calibration

Post by ibash » Thu Sep 23, 2021 7:25 am

I think it's built into the octoprint makergear setup:
Image

That said, I'd recommend asking support for written instructions, too.

Post Reply