Nozzle Life?
-
- Posts: 277
- Joined: Fri Oct 02, 2015 5:37 am
Re: Nozzle Life?
Yes, .6 Z Lift. Its not hitting on travel, it hits during extrusion of the next layer.
M2 - V4, MIC-6 Build Plate, Astrosyn Damper's(X/Y), Rev. E, Geeetech LCD
S3D - FFF Settings https://forum.simplify3d.com/viewtopic.php?f=8&t=2367
Print Quality Troubleshooting https://www.simplify3d.com/support/prin ... eshooting/
S3D - FFF Settings https://forum.simplify3d.com/viewtopic.php?f=8&t=2367
Print Quality Troubleshooting https://www.simplify3d.com/support/prin ... eshooting/