Where is the Makergear User Community?

[airscapes]

WOOHOO! Glad you were able to hang on.. American Made!!!

[Phil]

Great to hear, Rick!
Will you be at RAPID this year?

[msinger]

We've been rebuilding our supply chain - high prices and long lead times forced us to find new suppliers. It took several months just to get spare parts in stock and in late December we were finally able to start building new machines. We did not auction anything off - we started to but cancelled it and just focused on rebuilding.

What are your key goals for 2023?

I'm low-key scared that I won't be able to find parts for my M3-ID printers or be able to buy additional printers as my workload expands. Also, it doesn't feel like anything is being done to improve the MakerGear technology.

[airscapes]

We've been rebuilding our supply chain - high prices and long lead times forced us to find new suppliers. It took several months just to get spare parts in stock and in late December we were finally able to start building new machines. We did not auction anything off - we started to but cancelled it and just focused on rebuilding.

What are your key goals for 2023?

I'm low-key scared that I won't be able to find parts for my M3-ID printers or be able to buy additional printers as my workload expands. Also, it doesn't feel like anything is being done to improve the MakerGear technology.

I agree with you but keeping fingers crossed.
Parts are in good supply at this company. They reside in OH just a bit south of MG.. https://www.partsbuilt.com/

[theboz1419]

This is great news. I have had my M2 for about 7 years, now and I just had my first major part failure. My idler on the X axis had a bearing failure. I didn't think, I would find the store open or Makergear.

Boy, was I relieved when I was able to pick up two of them. Hopefully, I can get them soon to complete a project before I go on a vacation.

We've been rebuilding our supply chain - high prices and long lead times forced us to find new suppliers. It took several months just to get spare parts in stock and in late December we were finally able to start building new machines. We did not auction anything off - we started to but cancelled it and just focused on rebuilding.

What are your key goals for 2023?

I'm low-key scared that I won't be able to find parts for my M3-ID printers or be able to buy additional printers as my workload expands. Also, it doesn't feel like anything is being done to improve the MakerGear technology.

I agree with you but keeping fingers crossed.
Parts are in good supply at this company. They reside in OH just a bit south of MG.. https://www.partsbuilt.com/