Page 1 of 1

Second Nozzle Damaging Prints

Posted: Fri Mar 17, 2017 1:18 pm
by topflight70
I'm having an issue where the unused nozzle on my dual extruder M2 is damaging some prints. That is, the active nozzle will lay down a portion of a layer, z lift, and move to the next area within the same layer to lay down the next portion to continue; but the unused/inactive nozzle will strike and break the already printed area since it is now tall enough to be hit. The bed is level, and the nozzles are both the same height from the bed.

Is there any way other than physically raising the unused nozzle to compensate for this? Software is Simplify3D.